Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guida All'Installazione
Chapter 4 Operation
324
4039132 Rev B
Important: Selecting the SDV Session box triggers the SDV Manager to populate the
USRM Server Offered Progs source-specific multicast (SSM) address table for source
redundancy. Therefore:
USRM Server Offered Progs source-specific multicast (SSM) address table for source
redundancy. Therefore:
Check the SDV Session box when creating source definitions with the (default)
SDV MDA for multiple source locations.
SDV MDA for multiple source locations.
Uncheck the SDV Sessions box when creating source definitions for zone
programs.
programs.
To Configure Server Display Mode Using the Web Interface
Important: Before performing zone provisioning, you must set the Display Mode
parameter on the Applications.SdvSm.Configuration page to Config.
parameter on the Applications.SdvSm.Configuration page to Config.
The USRM Server implements tables with dynamic rows. In normal use, only rows
with defined entries are displayed. The Display Mode parameter lets you enable the
display of all rows of a table, including empty entries. This mode lets you configure
an entry in a table directly.
with defined entries are displayed. The Display Mode parameter lets you enable the
display of all rows of a table, including empty entries. This mode lets you configure
an entry in a table directly.
The Display Mode parameter is located on the Applications.SdvSm.Configuration
page of the USRM Server web interface. To add a new zone configuration or zone
program, set the Display Mode parameter to Config. Once configuration is
complete, be sure to reset the Display Mode to Normal.
page of the USRM Server web interface. To add a new zone configuration or zone
program, set the Display Mode parameter to Config. Once configuration is
complete, be sure to reset the Display Mode to Normal.
To Configure Zones Using the Web Interface
A USRM Server can support up to 10 separate zone configurations. Before creating
zones, you must first create zone configurations. To configure zones, you assign
names to each zone you want to set up.
zones, you must first create zone configurations. To configure zones, you assign
names to each zone you want to set up.
Note: The following steps refer to Web UI Pages under the Applications.SdvSm
section of the USRM Web UI.
section of the USRM Web UI.