Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guida All'Installazione
USRM Web Interface - Platform Components
78-4021139-01 Rev D
107
HaStandby - Primary Servers Page
The HaStandby - Primary Servers page configures the set of primary servers to be
supported by the standby.
Refer to HaPrimary - Network Config Page for an explanation of the high-
Refer to HaPrimary - Network Config Page for an explanation of the high-
availability function.
The following illustration shows the HaStandby - Primary Servers page.
The following illustration shows the HaStandby - Primary Servers page.
Parameters
The following table explains the HaStandby - Primary Servers page parameters.
The following table explains the HaStandby - Primary Servers page parameters.
Parameter
Description
Server
Displays the sequential server number in the list.
ServerID
The IP address of the primary server.
AdminState
Sets the administrative state of the primary server, as
follows:
InService - Indicates the standby is connected to the
InService - Indicates the standby is connected to the
primary server.
OutOfService - Indicates the primary is out of service
OutOfService - Indicates the primary is out of service
and the standby should not assume control for the
primary if it fails.
NotReady - Indicates that provisioning is not yet
NotReady - Indicates that provisioning is not yet
complete.
ForceSwitchover
Allows you to force a switchover. Selecting the On state
causes the standby server to transition to online, forcing
the primary offline if the standby is ready to take over for
the primary server.
Note: Control is returned when the primary server comes
Note: Control is returned when the primary server comes
back online.
ProtectMode
Indicates if automatic switching is to be performed.
When set to the Auto state, the standby will protect the
primary in the event of a failure. When set to Manual
mode, the standby will not automatically protect the
primary in the event of a failure.
ServerName
The name of the primary server.
ConnectTime
The date and time that the standby connected to the
primary.