Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guida All'Installazione
UCS USRM Quick Start Guide
78-4021139-01 Rev D
3
UCS USRM Quick Start Guide
Introduction
This manual contains information and instructions on UCS USRM hardware
installation, UCS USRM initial setup and startup, and UCS USRM software and
system configuration.
Perform the following steps, in order, to install and configure your UCS USRM.
Perform the following steps, in order, to install and configure your UCS USRM.
Step 1 - Read System Overview
Before starting any installation or configuration procedures, you should read
through all of Chapter 1 - Overview to gain a general understanding of the operation
of the UCS USRM.
Step 2 - Install the UCS USRM Hardware
Physically install the UCS USRM hardware and make all necessary rear panel
connections. Follow the detailed instructions in Hardware Installation (on page 25).
Step 3 - Perform the UCS USRM Initial Setup Procedure
Perform the UCS USRM initial setup by running the setup script. Follow the
detailed instructions under UCS USRM Setup Procedure (on page 313).
Step 4 - Configure the Virtual USRMs Network Information
Configure the IP addresses and hostnames for each of the virtual USRMs by
following the detailed instructions under Virtual UCS USRM Setup Procedure (on
page 315).
Step 5 - Start up Virtual USRMs and Create or Configure Network Resources
Perform USRM startup by following the detailed instructions under USRM Startup
Procedure (on page 312). Configure the virtual USRMs by browsing to the IP
address(es) configured in Step 4 and configuring the USRM as outlined in the
startup procedure.