Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guida All'Installazione
Chapter 6 OS Recovery, Software Re-Installation & Upgrade
416
78-4021139-01 Rev D
UCS CIMC
Introduction
The UCS Cisco Integrated Management Controller (CIMC) is the management
service for the USRM UCS Servers and all Cisco UCS C-Series servers. CIMC runs
within the server.
The UCS CIMC can be used for the following tasks, among others:
The UCS CIMC can be used for the following tasks, among others:
Power on, power off, power cycle, reset, and shut down the server.
Configure the server boot order.
View server properties and sensors.
Configure UCS CIMC network settings and access information.
Access the built in KVM for keyboard, video, or mouse control of the server over
the network.
Issue SNMP Notifications (traps) for hardware problems.
For a comprehensive guide to the UCS CIMC capabilities configuration, consult the
Cisco UCS C-Series Servers Integrated Management Controller GUI Configuration Guide.
Additionally, the UCS USRM can be integrated into the Cisco UCS Management
Additionally, the UCS USRM can be integrated into the Cisco UCS Management
platform. Refer to the appropriate UCS documentation for details.
Configuring UCS CIMC Network Settings
Follow these steps to configure the network settings for the CIMC.
1 Connect to the UCS USRM web interface.
2 Select UCS CIMC Configuration from the navigation tree on the left.
3 If necessary, change IP Address Source to either Static or DHCP as desired, and
1 Connect to the UCS USRM web interface.
2 Select UCS CIMC Configuration from the navigation tree on the left.
3 If necessary, change IP Address Source to either Static or DHCP as desired, and
then click Commit Changes.
Note: If DHCP is used, the acquired network settings are indicated. Use the
Note: If DHCP is used, the acquired network settings are indicated. Use the
indicated IP address and connect to the CIMC web interface. Otherwise,
continue.
4 Modify the IP Address, Subnet Mask, and Default IP Gateway fields to the
desired settings, and then click Commit Changes.
Note: By default, the CIMC interface uses the eth0 interface of the Cisco UCS server
and must be on the same subnet. To configure the CIMC for a subnet other than the
eth0 subnet, follow the instructions in Configuring a Dedicated LOM Port (on page