Cisco DNCS System Release 2.2 3.2
2-42
SR 2.2 and SR 3.2 Service Pack 2 Installation Instructions
78-4001158-01 Rev C
Reset the MQAM Modulator,
Continued
6.
Click File and then select Reset.
Result: A confirmation message appears.
Result: A confirmation message appears.
7.
Click Yes on the confirmation message.
Result: The modulator resets.
Result: The modulator resets.
8.
Wait a few minutes and then type ping [IP address] and press Enter to
ping each modulator you just reset.
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
when the modulator has been reset.
Note: It may take up to 5 minutes for each modulator to reset.
Note: It may take up to 5 minutes for each modulator to reset.
9.
Repeat steps 5 through 8 for up to seven additional modulators, and then
go to step 10.
Important: To maintain optional DNCS performance, do not reset more
Important: To maintain optional DNCS performance, do not reset more
than eight modulators at once. In step 11, you will have the opportunity to
reset additional modulators.
10. Wait a few minutes and then type ping [IP address] and press Enter to
ping each modulator you just reset.
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
when the modulator has been reset.
Note: It may take up to 5 minutes for each modulator to reset.
Note: It may take up to 5 minutes for each modulator to reset.
11. Do you have additional modulators to reset?
•
If yes, repeat steps 5 through 10 as many times as necessary until all of
your modulators have been reset, and then go to step 12.
•
If no, go to step 12.
12. Click File and then select Close to close the QAM List window.