Cisco Cisco RF Gateway 1 Guida All'Installazione
7019288 Rev A
11
Upgrade Procedure for Customers Running 1.02.09
Upgrade Procedure for Customers Running 1.02.09
WARNING:
Upgrading to 2.01.09 directly from 1.02.09 must not be attempted. This may
Upgrading to 2.01.09 directly from 1.02.09 must not be attempted. This may
cause the RF Gateway 1 to become non-operational.
1 Before starting the upgrade, back up the system configuration. Refer to Chapter
3, General Configuration and Monitoring (Configuration Backup) of the Cisco RF
Gateway 1 Configuration Guide, part number 4025112. Name the file appropriately
to identify it as a configuration that corresponds to 1.02.09. This file will be
necessary later if the user decides to revert back to 1.02.09.
Gateway 1 Configuration Guide, part number 4025112. Name the file appropriately
to identify it as a configuration that corresponds to 1.02.09. This file will be
necessary later if the user decides to revert back to 1.02.09.
2 Record the IP port configuration parameters by saving a screen capture of the
System/IP Network page. Refer to Recording IP Port Configuration Settings (on
page 14).
page 14).
3 Download and activate 1.02.19. Refer to Chapter 3, General Configuration and
Monitoring (Release Management) of the Cisco RF Gateway 1 Configuration Guide,
part number 4025112. The RF Gateway 1 reboots automatically at the end of the
upgrade process.
part number 4025112. The RF Gateway 1 reboots automatically at the end of the
upgrade process.
4 After reboot, display the System/IP Network page. Refer to Displaying IP Port
Configuration Settings (on page 13).
5 Verify the IP port configuration parameters by checking them against those
recorded in step 2 (prior to the upgrade as done in step 3). The Negotiation
Mode, Redundancy Mode, and Revert Mode parameter values are inverted.
Refer to Displaying IP Port Configuration Settings (on page 13). Change the
differing parameter values to match those recorded before download and
activation. Be sure to click Apply after making your changes.
Mode, Redundancy Mode, and Revert Mode parameter values are inverted.
Refer to Displaying IP Port Configuration Settings (on page 13). Change the
differing parameter values to match those recorded before download and
activation. Be sure to click Apply after making your changes.
6 Once step 5 is completed, save the configuration which includes the IP port
configuration parameters. Going forward, these values will not change.
7 Validate/qualify/soak release 1.02.19 in its application to establish confidence
the release is operating at the same level as 1.02.09. In the very unlikely event
service is impacted by 1.02.19, reverting back to 1.02.09 may be done to re-
establish operations. If reverting back to 1.02.09 is necessary, the IP port
configuration parameters must be swapped back and the configuration saved in
step 2 restored.
service is impacted by 1.02.19, reverting back to 1.02.09 may be done to re-
establish operations. If reverting back to 1.02.09 is necessary, the IP port
configuration parameters must be swapped back and the configuration saved in
step 2 restored.