Cisco Cisco StadiumVision Director Manuale Di Manutenzione
© 2012 Cisco Systems, Inc. All rights reserved.
Page 24 of 103
Figure 18.
S-Video to Component Connection
If using a DMP S-video output to component converter cable, you need to configure
the DMP to enable the component interface. This can only be done via the Display
Actions web page on the DMPDM interface, or by directly addressing the DMP MIB.
There is no way to select the component interface from within Cisco StadiumVision
Director.
the DMP to enable the component interface. This can only be done via the Display
Actions web page on the DMPDM interface, or by directly addressing the DMP MIB.
There is no way to select the component interface from within Cisco StadiumVision
Director.
The following screen shows an example configuration of a DMP connected via the
component cable with the 1080i59 as its Display Standard. Other Display Standards
may be used for different TV models.
component cable with the 1080i59 as its Display Standard. Other Display Standards
may be used for different TV models.
Figure 19.
Setup to Enable 1080i Component Output From the DMP 4310