Cisco Cisco StadiumVision Director Manuale Di Manutenzione
© 2011 Cisco Systems, Inc. All rights reserved.
Page 78 of 94
You can tune a TV to blank channel using the DMP Device Manager UI or you can
create a blank channel in StadiumVision Director. To tune to a blank channel
through the DMP Device Manager:
create a blank channel in StadiumVision Director. To tune to a blank channel
through the DMP Device Manager:
1. Access the DMP Device Manager main page.
2. In the Display Actions list, click Video Multicast.
3. Enter a multicast address, but leave the group port number blank, as shown
below.
Verifying the Behaviour of a Replaced DMP
Situation: Due to a hardware failure or an optional upgrade, a DMP that is already
defined in StadiumVision Director must be replaced.
defined in StadiumVision Director must be replaced.
Challenge: When you replace a DMP, verify that the new DMP follows the same
scripted behavior as the previous DMP. The new DMP should:
scripted behavior as the previous DMP. The new DMP should:
Belong to the same groups and zones.
React to the zone/group state actions.
Display the same content as the rest of the group
Receive and display all proper content that was received and displayed by the
old DMP.
Solution: To verify that the DMP can be replaced before an event and participate in
that event:
that event:
1. Unplug the existing DMP and replace it with a DMP that already has the latest
firmware and SVD version.
2. Verify the following:
The new DMP is active.
If static DHCP is used or the new DMP is assigned to the same IP address
as the swapped-out DMP, the new DMP resumes the identity of the replaced
DMP with the pre-assigned groups, zones, and corresponding state actions.
DMP with the pre-assigned groups, zones, and corresponding state actions.
3. Manually push the Flash Template to the new DMP.
4. Start the event script and make sure the new DMP follows the script.
Note: DMP 4305Gs and 4310s should be in separate groups and not mixed. You
can verify that no groups contain a mix of 4305G and 4310 by clicking Schedule in
the Control Panel in StadiumVision Director, as shown below.
can verify that no groups contain a mix of 4305G and 4310 by clicking Schedule in
the Control Panel in StadiumVision Director, as shown below.