Cisco Cisco StadiumVision Mobile Reporter

A known problem in the deployment of VMware OVA templates can occur with the Cisco StadiumVision 
Director Remote OVA template, where sometimes the Linux OS creates a new “eth0” network interface 
and renames the original one to “eth0.bak.” If this happens, ignore the “eth0.bak” interface and configure 
the network using the “eth0” interface.

For more information about installing Cisco StadiumVision Director Remote, see the 

.

Platform 2 (SV-DIRECTOR-K9 or SV-PLATFORM2=) of the Cisco StadiumVision Director server 
requires installation of the Unified Computing System (UCS) Server Firmware Version 1.4(2) or later to 
avoid problems powering off the server hardware.

You can verify the firmware version installed on Platform 2 of the Cisco StadiumVision Director server 
by running a Basic System State Report from the Cisco StadiumVision Director main menu.

BIOS firmware version 1.4.1 is the compatible version packaged with CIMC firmware version 1.4.2.

In the OS Information section of the Basic System State Report, look for “BIOS Information” and 
“Version” below the “Handle 0x00005, DMI type 0, 24 bytes” line, as shown in the following example.

If your version is less than “1.4.1,” then an upgrade is needed:

Handle 0x0005, DMI type 0, 24 bytes.

BIOS Information

Vendor: Cisco Systems, Inc.

Version: C200.1.1.1a.0.032920100525

Release Date: 03/29/2010

If the vendor information in this section is Intel Corporation, and the version begins with 
“S5000,” then this is not a Platform 2 server, but rather a Cisco ADE 2140 Series server. This 
BIOS upgrade process does not apply to the Cisco ADE 2140 Series server.

For more detailed information about verifying the BIOS firmware and instructions about how to 
upgrade, see the “Upgrading the CIMC and BIOS Firmware on a Cisco StadiumVision Director 
Platform 2 Server” module of the