Cisco Cisco 870 MHz GainMaker Amplifiers Guida All'Installazione
Chapter 2 Installation and Configuration
26
Signal Flow from Right to Left
Note: Coax In may be switched with the Coax Out if you reverse the line
extender module and feed the signal from right to left.
extender module and feed the signal from right to left.
5 Using a ½-inch torque wrench, tighten the strand clamp bolts from 5 ft-lb to 8
ft-lb (6.8 Nm to 10.8 Nm). Make sure there is good mechanical contact between
the strand and the housing.
Note: A slight tilt of the face of the housing is normal. Cable tension will cause
the housing to hang more closely to vertical.
the strand and the housing.
Note: A slight tilt of the face of the housing is normal. Cable tension will cause
the housing to hang more closely to vertical.
6 Connect the coaxial cable to the pin connector according to connector
manufacturer specifications.
7 Proceed to Installing Accessories (on page 28).
To Install the Housing in a Pedestal
Complete the following steps to install the line extender in a pedestal.
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and
strand clamps aside.
3 Position the housing in the pedestal frame as shown in the following illustration.
Line up the self-tapping bolt holes on the bottom of the housing with the
mounting holes on the bracket.
mounting holes on the bracket.