Cisco Cisco 1 GHz GainMaker Amplifier Guida All'Installazione
Installing Accessories
29
GainMaker Line Extender. The illustration above shows a typical example.
The interstage pad is installed at the factory to set the operational gain of the
station. Do not change this pad in the field unless required by system design.
station. Do not change this pad in the field unless required by system design.
3 Install other options or accessories as desired, or proceed to Installing the Line
Extender Module (on page 33).
To Install Equalizers
Complete the following steps to install the equalizers in the line extender.
Note: For best results, follow this installation procedure exactly.
1 Begin this procedure with the housing open. Refer to To Open the Line Extender
1 Begin this procedure with the housing open. Refer to To Open the Line Extender
Housing (on page 15).
Note: These accessories can be installed without removing the line extender
module cover.
Note: These accessories can be installed without removing the line extender
module cover.
2 Install the forward input equalizer specified by the design print in the forward
input equalizer slot. Or, install the correct inverse equalizer specified by the
design print for your system in the forward input equalizer slot. For a list of
available accessory pad values and part numbers, see datasheet.
design print for your system in the forward input equalizer slot. For a list of
available accessory pad values and part numbers, see datasheet.
Note:
Be sure that all the pins on the forward input equalizer or inverse equalizer