Cisco Cisco Prisma II EDR Receiver Guida All'Installazione
Chapter 2 System Installation
24
OL-32414-01
4 Connect RF cables to the Port B and Port D connectors for the chassis slot in
which the module will be installed. These are the RF output connections for the
module in the upper half-slot position. Hand-tighten the connectors.
module in the upper half-slot position. Hand-tighten the connectors.
5 Route the RF cables from Ports B and D (for the upper half-slot module) to the
appropriate RF destinations.
6 If F connectors are installed, use a 7/16-in. open-end wrench to secure all cables
to the connectors at the chassis.
Prisma II XD Chassis
1 Attach a 75-ohm RF cable to the appropriate RF signal source.
2 Locate the numbered RF ports at the back of the chassis.
1 Attach a 75-ohm RF cable to the appropriate RF signal source.
2 Locate the numbered RF ports at the back of the chassis.
3 Attach the other end of the RF cable to the Port A connector of the second slot
where the module is to be installed (slot 2 in the example shown). This is the RF
input connection.
input connection.
4 Use a 7/16-in. open-end wrench to secure all cables to the F connectors at the
chassis.