Cisco Cisco OptoStar II Driver Amplifier Guida All'Installazione
Installing/Removing the Modules, Continued
5. Slide module in smoothly until you feel slight resistance, then continue to
push gently until the module connector seats completely.
Note: Check alignment if you feel significant resistance. Do not press hard,
otherwise the connector may be damaged. When installing the module in the
slot, ensure the proper connector alignment.
Note: Check alignment if you feel significant resistance. Do not press hard,
otherwise the connector may be damaged. When installing the module in the
slot, ensure the proper connector alignment.
6. Tighten the mounting screws on the lower front panel of the module by hand
or screwdriver, to secure the module in the chassis.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
7. Repeat the steps above if more modules need to be installed.
8. Connect the fiber.
8. Connect the fiber.
Continued on next page
OL-29666-02
Installation
2-5