Cisco Cisco OptoStar II 1310nm Transmitter Guida All'Installazione
Operating using NMS Software, Continued
Setup Parameters
The table below lists the setup parameters of the OptoStar II 1550 nm DWDM
forward direct modulation transmitter.
forward direct modulation transmitter.
Setup Parameters
Description
Factory Default
RF Input Information
Gain Control Mode
Gain Control Mode
Selection
Shows / sets AGC or MGC gain
control mode
AGC mode
RF attenuation
Shows / sets RF attenuation (dB)
(In AGC mode the field is grayed
out; In MGC mode the function is
available: gain range -5 to +5 dB,
with 0.5 dB step)
0 dB (In AGC mode)
Laser Information
Laser ON/OFF
Laser ON/OFF
switch
Shows / sets laser status: ON/OFF Laser status: ON
Comment
Comment
You may add applicable comments
as required.
None
3-32 Operation
OL-29668-02