Cisco Cisco OptoStar II Driver Amplifier Guida All'Installazione

Pagina di 77
Operating using ICIM LCD, Continued 
Sub-menu 3 -- Optical Output Alarm Threshold 
The illustration below shows sub-menu 3 of the OptoStar II 1550 nm DWDM 
forward direct modulation transmitter module – Optical Output Alarm 
Threshold. 
 
The optical output alarm threshold lower limit is (standard value - 2.2) dBm; and 
upper limit is (standard value + 1.5) dBm. The cursor stays in the “Low” field by 
default. 
• 
To configure the lower limit of the optical alarm threshold (minimum output 
power is no less than (standard value - 2.2) dB): 
1.  Press SET button to start the configuration; 
2.  Press ▲▼ buttons to change the value, and press SET button to confirm; 
3.  Press ► button to move the cursor to “Set”; 
4.  Press “SET” button to save the configuration. 
• 
To configure the upper limit of the optical alarm threshold (maximum output 
power is no more than (standard value + 1.5) dB):   
1.  Press ▼ button to move the cursor to the “High” field; 
2.  Press SET button to start the configuration; 
3.  Press ▲▼ buttons to change the value, and press SET button to confirm; 
4.  Press ► button to move the cursor to “Set”; 
5.  Press SET button to save the configuration. 
 
Continued on next page 
 
 
 
3-12                                            Operation 
  OL-29668-02