Cisco Cisco OptoStar II 1550nm EDFA Guida All'Installazione
Important Safety Instructions
Read and Retain Instructions
Carefully read all safety and operating instructions before operating this equipment,
and retain them for future reference.
Follow Instructions and Heed Warnings
Follow all operating instructions. Pay attention to all warnings and cautions in the
operating instructions, as well as those that are affixed to this equipment.
Terminology
T
he terms defined below are used in this document. The definitions given are based
on those found in safety standards.
Service Personnel-The term service personnel applies to trained and qualified
Service Personnel-The term service personnel applies to trained and qualified
individuals who are allowed to install, replace, or service electrical equipment. The
service personnel are expected to use their experience and technical skills to avoid
possible injury to themselves and others due to hazards that exist in service and
restricted areas.
User and Operator-The terms user and operator apply to persons other than service
User and Operator-The terms user and operator apply to persons other than service
personnel.
Ground(ing) and Earth(ing)-The terms ground(ing) and earth(ing) are synonymous.
Ground(ing) and Earth(ing)-The terms ground(ing) and earth(ing) are synonymous.
This document uses ground(ing) for clarity, but it can be interpreted as having the
same meaning as earth(ing).
Electric Shock Hazard
T
his equipment meets applicable safety standards. Refer to this equipment’s data
sheet for details about regulatory compliance approvals.
WARNING:
Avoid electric shock! Opening or removing the equipment cover may expose
you to dangerous voltages. Refer all servicing to qualified service personnel
only.
Electric shock can cause personal injury or even death. Avoid direct contact with
dangerous voltages at all times.
Know the following safety warnings and guidelines:
•
Know the following safety warnings and guidelines:
•
Only qualified service personnel are allowed to perform equipment installation or
replacement.
•
Only qualified service personnel are allowed to remove equipment covers and
access any of the components inside the chassis.
Continued on next page
vi
Safety OL-29659-03