Cisco Cisco OptoStar II Driver Amplifier Guida All'Installazione

Pagina di 64
Connections 
RF Cable Connections 
Although the modules may be hot-swapped when service must be restored, it is 
recommended that the chassis and modules are installed prior to powering up the 
chassis.
 
Use a cable with F-type male RF connector (3/8-32 UNEF thread) to connect the 
RF input port A, RF output port B and RF output port on the rear panel of the 
module. See the illustration below for RF cable connections. 
 
 
 
 
2-6 
Installation 
OL-29669-02