Cisco Cisco Prime Collaboration Assurance 11.5 Libro bianco

 

 

© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 

Page 11 of 40 

Please refer to the Quick Start Guide at 

 for the exact VMware 

reservation requirements. 

Please refer to the Quick Start Guide at 

. 

You need to download the OVA images for Cisco Prime Collaboration Assurance and Cisco Prime Collaboration 

Provisioning and install them on separate VMs. If you need only one or the other, then download just the required 

OVA and deploy that. OVAs are available for each deployment, small, medium, large, and very large. Note that 

there is no separate OVA for analytics. The Cisco Prime Collaboration Assurance OVA contains the Analytics 

component, which can be enabled if appropriate optional licensing is applied. 

Please refer to the Quick Start Guide at 

 for the OVA details. 

It is recommended that you know the values beforehand for the following parameters as you are required to specify 

them at the console prompts while configuring the virtual appliance: 

● 

IP Address: The IP address of the virtual appliance 

● 

IP default netmask: The default subnet mask for the IP address 

● 

IP default gateway: The IP address of the default gateway 

● 

Default DNS domain: The default Domain Name System (DNS) name 

● 

Primary nameserver: The primary name server. You may add the name server. To configure several name 

servers, enter y 

● 

Primary NTP server [time.nist.gov]: The primary Network Time Protocol (NTP) server 

To enter a secondary NTP server, enter y at the next prompt. 

● 

Timezone: The time zone set for Cisco Prime Collaboration. When you are prompted to enter the system 

time zone, specify the default time zone - UTC. You can use Secure Shell (SSH) Protocol to change the 

time zone after you install the Cisco Prime Collaboration Assurance or Cisco Prime Collaboration 

Provisioning server; the time stamp that is displayed on the UI is the server time. You must use the same 

time zone for Cisco Prime Collaboration Assurance and Cisco Prime Collaboration Provisioning servers in 

converged mode. For a list of supported time zones, see 

.” 

● 

Username: The command-line interface (CLI) admin user name. The user name is admin by default. 

However, you can specify the user name of your choice.