Cisco Cisco Prisma II EDR Receiver Guida All'Installazione
Installing the Module in the Chassis
78-4023013-01 Rev C
21
Note: Do not force or bang the host module into the chassis. If properly aligned,
the host module should slide in with minimal force.
4 Hand-tighten the screw at the top of the host module to ensure that the first few
threads engage smoothly. Use a 3/8-in. flat-blade screwdriver to secure the
mounting screw. Do not over-tighten.
To Install the Module in a Prisma II XD Chassis
Note: This procedure assumes that the chassis is installed in a rack.
WARNING:
Avoid damage to your eyes! Do not look into any optical connector while the
system is active. Even if the unit is off, there may still be hazardous optical
levels present.
Complete the following steps to install the module in the chassis.
CAUTION:
Always use a screwdriver to loosen or tighten the screws holding the
Always use a screwdriver to loosen or tighten the screws holding the
application modules, ICIM2-XD, fan assembly, power supply modules, DC-to-
DC converters, or blanking panels in place. Do not attempt to loosen or
tighten these screws solely by hand.
1 Locate the fiber guides at the bottom of the chassis and the module guide slots
inside the chassis as shown in the following illustration.