Intel D915GLVGL Manuale Utente

Pagina di 84
Technical Reference 
 59 
2.11.3  Fan Connector Current Capability 
 CAUTION 
The processor fan must be connected to the processor fan connector, not to a chassis fan 
connector.  Connecting the processor fan to a chassis fan connector may result in onboard 
component damage that will halt fan operation. 
Table 30 lists the current capability of the fan connectors. 
Table 30.  Fan Connector Current Capability 
Fan Connector 
Maximum Available Current 
Processor fan 
1000 mA 
Front chassis fan 
600 mA 
Rear chassis fan 
600 mA 
2.11.4  Power Supply Considerations 
 CAUTION 
The +5 V standby line for the power supply must be capable of providing adequate +5 V standby 
current.  Failure to do so can damage the power supply.  The total amount of standby current 
required depends on the wake devices supported and manufacturing options.   
System integrators should refer to the power usage values listed in Table 29 when selecting a power 
supply for use with the board. 
Additional power required will depend on configurations chosen by the integrator. 
The power supply must comply with the following recommendations found in the indicated 
sections of the ATX form factor specification. 
•  The potential relation between 3.3 VDC and +5 VDC power rails (Section 4.2) 
•  The current capability of the +5 VSB line (Section 4.2.1.2) 
•  All timing parameters (Section 4.2.1.3) 
•  All voltage tolerances (Section 4.2.2)