Cisco Cisco TelePresence MX700 Dépliant
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.02 Administering TC6.1 Endpoints on CUCM 9.1.1, April 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
35
Using the Touch panel
1. Tap gently on the Touch screen if the unit
is in sleep mode.
2. Navigate to (Settings) > Administrator
> Reset.
3. Tap the Factory Reset button.
4. The system will revert to the default
factory settings and automatically restart.
This will take a few minutes.
Using the remote control
1. Start a command line interface (for
example PuTTY). Enter the host name
(or IP address) of the codec and set
connection type to SSH.
2. Log in with the appropriate username and
password.
3. run the following command:
xCommand
SystemUnit FactoryReset Confirm:
Yes
4. The system will revert to the default
factory settings and automatically restart.
This will take a few minutes.
Using the power button
Applies to SX20/EX60/EX90.
1. Power down the system by pressing
gently and hold the power button until the
system shuts down. The power LED turns
off.
2. Press gently and hold the power button
for 10 seconds. During this period the
power LED will remain off.
3. release the button and within four
seconds, press twice. During this period
the power LED will blink.
4. The system will revert to the default
factory settings and automatically restart.
When up and running again the LED lights
continuously.
NOTE:
If you failed to press the power
button within the four seconds, the
system will not revert to the default
factory settings, and you will not see the
confirmation message. If this happens, go
back to Step 1.
Using the web interface
1. Open a web browser and enter the
IP address of the video system in the
address bar.
2. Navigate to Maintenance > Factory Reset.
3. read the provided information carefully
before you check the I want to reset...
check box
4. Click Perform a factory reset.
5. The system will revert to the default
factory settings and automatically restart.
This will take a few minutes.
Factory resetting the TelePresence endpoint
When factory resetting the endpoint the following happens:
• The call logs will be deleted.
• All system parameters will be reset to default values.
• All files uploaded to the system will be deleted.
• The release key and Option key will be preserved.
• Automatic restart of the system.
•
• All system parameters will be reset to default values.
• All files uploaded to the system will be deleted.
• The release key and Option key will be preserved.
• Automatic restart of the system.
•
NOTE:
It is not possible to undo a factory reset.
Make sure to collect the call logs before factory resetting the
endpoint. refer to
After the factory reset a notification will display on the main
screen for about 10 seconds.
After the factory reset you will need to re-configure the
endpoint. refer to:
.
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
Appendices