Cisco Cisco TelePresence MX700 Manuale Di Manutenzione
Enable auto-registration of the TelePresence endpoint.
Log in to Cisco Unified CM Administration and navigate to System > Cisco Unified CM.
Log in to Cisco Unified CM Administration and navigate to System > Cisco Unified CM.
Auto-registration of the endpoint
Either you follow the manual registration process described in this chapter, or
you can configure the CUCM for auto-registration of the endpoint.
Auto-registration of the TelePresence endpoint is not possible when
the Cisco Unified CM is set to mixed mode (cluster security mode).
Enable auto-registration
1. Navigate to System > Cisco Unified CM.
Search to find the Cisco Unified Communication Manager
2. Use the search options available on the page, or leave the search field
blank and press Find to list all.
3. Select your Cisco Unified CM from the list.
Auto-registration Information
4. Navigate to the Auto-registration Information section.
Auto-registration Disabled on this Cisco Unified Communications
Manager: Uncheck the check box to enable auto-registration.
Click Save and Apply Config.
4
1
System
Cisco Unified CM
2
3
Cisco TelePresence Endpoints running TC5 and Cisco Unified Communications Manager 8.6
Quick Reference Guide
D14878.06 Administering TC5 Endpoints on CUCM 8.6, January 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
22
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
CUCM configuration