Cisco Cisco TelePresence MX700 Manuale Di Manutenzione
Cisco TelePresence Endpoints running TC5 and Cisco Unified Communications Manager 8.6
Quick Reference Guide
D14878.06 Administering TC5 Endpoints on CUCM 8.6, January 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
8
API
WEB
Using the command line interface
When you know the IP address you can configure the
endpoint from a command line interface by API commands.
Signing in through SSH
1. Start a command line interface (for example PuTTY).
Enter the host name (or IP address) of the codec and set
connection type to SSH.
2. Log in with the appropriate username and password.
The default user name is admin with no password set.
3. Issue the commands as described later in this guide.
If you are not able to connect to the system:
• Make sure the endpoint and computer are connected to
the same network.
• Make sure the endpoint is connected to power and
switched on.
• If the system has just been switched on, wait for a few
minutes to allow the system to start up.
• If in doubt, read the Installation guide for your product.
Preparations
(continued...)
You can use the Touch controller or the remote control to
configure the system; alternatively, you can use the system's
web interface or the command line interface with API
commands.
All methods are described on the following pages.
Finding the IP address using the Touch controller
Tap
Tap
More > Settings ( ) > System Information
on the Touch
controller. If an IPv4 or IPv6 address is assigned to the
system, you will find it in the Network section.
Finding the IP address using the remote control
Use the remote control and go to
Use the remote control and go to
Home > Settings > System
Information
. If an IPv4 or IPv6 address is assigned to the
system, you will find it on the System Information page.
Using the web interface
When you know the IP address you can configure the
endpoint from the web interface.
Signing in to the web interface
1. Open a web browser and enter the system’s IP address in
the address bar.
2. Enter your user name and password and click
Sign In
.
The default user name is admin with no password set.
If you are not able to connect to the system:
• Make sure the endpoint and computer are connected to
the same network.
• Make sure the endpoint is connected to power and
switched on.
• If the system has just been switched on, wait for a few
minutes to allow the system to start up.
• If in doubt, read the Installation guide for your product.
Saving changes
Click the
Click the
ok
button, to the right of most menu items, to save
and make the change take effect.
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
Endpoint configuration