Cisco Cisco Prisma II EDR Receiver Guida All'Installazione
3-22
Operation Using the ICIM
78-748704-01 Rev C
Configure the Processor Using the ICIM
Introduction
The ICIM allows you to configure parameters for the processor.
CONFIG Parameters
The table below shows configurable parameters for the processor.
Parameter
Functions
Values
Default
Recv1
Configures receiver 1 active or idle.
Active or Idle
Active
RednRcv1
Configures receiver 1 as Master (with
or without a backup), Internal (backs-
up the other receiver in the same
processor), or External (backs-up
another receiver in a separate
processor). See note below.
Master, Internal, or
External
Master
RFOut_1A
RFOut_1B
Controls the muting of RF channels 1A
and 1B. If Auto, the CCB determines if
the output should be muted (only if in
a redundancy mode). If On, the output
is not muted. If Off, the output is
muted.
Auto, On, Off
Auto
RFAttn1A
RFAttn1B
Attenuates the RF output channels 1A
and 1B.
0 dB to 10 dB
0 dB
Recv2
Controls whether receiver 2 is active or
idle.
Active or Idle
Active
RednRcv2
Configures receiver 2 as Master (with
or without backup), Internal (backs-up
the other receiver in the same
processor), or External (backs-up
another receiver in a separate
processor). See note below.
Master, Internal, or
External
Master
RFOut_2A
RFOut_2B
Controls the muting of RF channels 2A
and 2B. If Auto, the CCB determines if
the output should be muted (only if in
a redundancy mode). If On, the output
is not muted. If Off, the output is
muted.
Auto, On, Off
Auto
RFAttn2A
RFAttn2B
Attenuates the RF output channels 2A
and 2B.
0 dB to 10 dB
0 dB
Note: Both receivers in a single processor may also be set to Master with or without
external redundancy. See Processor Configuration Options in Chapter 1.