Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch Riferimenti tecnici
Administration
PoE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
38
2
Related Commands
PoE
The following commands configure the Power-over-Ethernet functionality on the
switch.
switch.
NOTE
These commands are valid only for the SF 200E-24P and SF 200E-48P switches.
lldp med transmit-tlv
Use this command to specify the optional Type Length Values (TLVs) in the LLDP
MED set transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs) on
a specific port. Use the
MED set transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs) on
a specific port. Use the
no form of the command to exclude the specified TLV for
the specified port.
lldp med transmit-tlv [capabilities] [ex-pse] [inventory] [location] [network-policy]
no lldp med transmit-tlv [capabilities] [ex-pse] [inventory] [location] [network-
policy]
TEMP
Internally measured transceiver temperature.
Voltage
Internally measured supply voltage.
Current
Measured TX bias current.
Output Power
Measured TX output power in milliwatts.
Input Power
Measured RX received power in milliwatts.
TX Fault
Transmitter fault.
LOS
Loss of signal.
Command
Description
show cablestatus
Displays the cable connection status on a selected port.