Zebra 01219-901 Manuale Utente
Maintenance
Fault Finding
Fault Finding
88
P1003643-001
TTP 1020™/TTP 1030™ Technical Manual
03/03/2009
No cutting
•
Check that the connectors for the cutting motor/home-
position switch are fully seated on the control board.
position switch are fully seated on the control board.
Bad cutting (uneven top
and bottom document
edges).
and bottom document
edges).
•
Remove power from the printer and then remove any
obstructing paper particles in the cutter and presenter
modules.
obstructing paper particles in the cutter and presenter
modules.
Inconsistent cutter
operation
operation
•
Check cutter-home switch.
Paper is fed straight
through the printer. Paper
does not loop.
through the printer. Paper
does not loop.
•
Check presenter sensor.
Missing print or irregular
spots.
spots.
•
Paper may be too humid. Let it adapt to ambient
temperature and humidity for approximately 24 hours
before use.
temperature and humidity for approximately 24 hours
before use.
•
The paper used might not meet the paper specification.
See
See
.
White longitudinal lines in
the printout.
the printout.
•
Replace print head or print module.
Faint print.
•
The paper used might not meet the paper specification.
See
See
.
•
Clean print head with isopropyl alcohol.
Strange characters or
graphics printed, or any
kind of strange printer
behavior.
graphics printed, or any
kind of strange printer
behavior.
•
Might be caused by erroneous data sent from the host, or
that the flow control signals between host and printer .
Check validity of transferred data.
that the flow control signals between host and printer .
Check validity of transferred data.
Symptom
Suggested actions