Brother ADS-3000N Guida Utente
Configuring Your Machine for a Wireless Network (ADS-2800W / ADS-3600W)
18
3
A
Disconnect the USB cable between the computer and the machine.
B
Click Finish.
Using WPS (Wi-Fi Protected Setup™)
3
1
Confirm that your wireless access point/router has the WPS symbol as shown below.
2
Place the Brother machine within range of your wireless access point/router. The range may differ
depending on your environment. Refer to the instructions provided with your wireless access
point/router.
depending on your environment. Refer to the instructions provided with your wireless access
point/router.
3
On the machine’s LCD, press
> Network > WLAN > WPS.
When Enable WLAN? appears, press Yes to accept.
NOTE
• If you do not start WPS from the machine’s LCD a few seconds after pressing the WPS button on your
wireless access point/router, the connection may fail.
• If your wireless access point/router supports WPS and you want to configure your machine using the PIN
(Personal Identification Number) Method, see Using the PIN Method of Wi-Fi Protected Setup™ (WPS)
on page 19.
on page 19.
4
When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router
(for more information, see the instructions provided with your wireless access point/router).
(for more information, see the instructions provided with your wireless access point/router).
Press OK on your Brother machine’s LCD.
5
Your machine automatically detects which mode (WPS) your wireless access point/router uses, and tries
to connect to your wireless network.
to connect to your wireless network.
6
If your wireless device is connected successfully, the LCD displays the message Connected until you
press OK.
The wireless setup is now complete. The Wi-Fi light
on the Control Panel lights up, indicating that
the machine’s network interface is set to WLAN.