Samsung AQ09TSBNEUR Manuale Utente

ENGLISH

Purging the indoor unit

1. Unscrew the caps at the end of each pipe.



All inert gas exhausts from the indoor unit.

1. Make sure that you have all the required tools (pipe cutter, reamer, flaring tool and pipe holder).

2. If you want to shorten the pipe, cut it using a pipe cutter, ensuring that the cut edge remains at 90° with the side of the

pipe (see below examples of correct and incorrect cut edges).

3. To prevent a gas leak, remove all burrs at the cut edge of the pipe using a reamer.

4. Put a flare nut slightly into the pipe and modify the flare.

The indoor unit is supplied with inert gas (nitrogen).
Before installing the unit, check if nitrogen gas flow out of indoor unit.
If this one isn’t true, DO NOT INSTALL THE UNIT since leakage could be inside the indoor unit.

The length of the pipe can be:
• Extended up to : see table page 24
• Shorten up to: see page 24

If you need a pipe longer than 5 meters:
• You must extend the assembly cable.
• You must add refrigerant to the pipes; otherwise, the indoor unit may freeze.

Unscrew the caps

Pipes

Oblique

Rough

Burr

Pipe

cutter

Pipe

• The remaining air in the Refrigeration cycle, which contains moisture,

may cause malfunction on the compressor.

• Always contact the service center or a professional installation agency

for product installation.

• To prevent dirt or foreign substances from getting into the pipes during

installation, do NOT remove the caps completely until you are ready to

connect the pipes.

Cutting or extending the pipe

Outer Diameter (D)

Depth (A)

Flaring Size (B)

ø6.35 mm

1.3 mm

9.0 mm

ø9.52 mm

1.8 mm

13.0 mm

ø12.70 mm

2.0 mm

16.2 mm

ø15.88 mm

2.2 mm

19.3 mm

ø19.05 mm

2.2 mm

22.5 mm

ø22.23 mm

2.2 mm

25.7 mm

Pipe

Flare

• Face the pipe down while removing the burrs to make sure that burrs do not get in to the pipe.