Samsung SNT-1010P Manuale Utente
61
Chapter 8 Setting Up
System Configuration
60
Setting Up
To reset the system
If the system abnormally operates or a problem occurs, you can restart or reset the system.
<Restart> : The Reset window appears.
<Factory Default> : Initializes the system settings to the
factory settings and then restarts the system.
factory settings and then restarts the system.
- <Except Network Parameter>: Initializes the system settings except
network settings.
- <All> : Initializes all the system settings. Selecting this option is the same as
pressing the [FACTORY RESET] button on the rear panel of the main body.
After reset and restart, you have to connect to the system again.
It takes a few minutes until the system booting is completed.You cannot connect to the system until the system booting is complete.
After running <Factory Default>
It takes a few minutes until the system booting is completed.You cannot connect to the system until the system booting is complete.
After running <Factory Default>
<All>, you have to run <IP Installer.exe> program and setup network settings such as IP
address, Subnet mask, Gateway, etc., to connect to the Internet.
Notice
System Configuration
(Continued)
Click <SYSTEM>
<RESET>.
The Reset window appears.
Click <SYSTEM>
<RS485>.
The RS485 window appears.
To setup RS485
Setup the RS485 port of the system
To complete the setting, click the
[Apply] button.
[Apply] button.
The settings are saved.
The settings must be the same as those of the camera connected to the SNT-1010.
Notice