Samsung RF263 Tipo Europeo con Twin Cooling Plus™, 682 L Manuale Utente
operating
_17
02 OPERA
TING
Removing any residual matter inside
the water supply line after installing
the water fi lter.
the water supply line after installing
the water fi lter.
Turn ON the main water
1.
supply and supply water
from water supply line.
Run water through the
from water supply line.
Run water through the
2.
dispenser until the water
runs clear (approx. 6 to
7 minutes). This will clean the water supply
system and remove air from the lines.
Additional fl ushing may be required in some
runs clear (approx. 6 to
7 minutes). This will clean the water supply
system and remove air from the lines.
Additional fl ushing may be required in some
3.
households.
Open the Refrigerator door and make sure
Open the Refrigerator door and make sure
4.
there are no water leaks coming from the
water fi lter.
water fi lter.
Be sure to fl ush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT:
IMPORTANT:
The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 241
and 827 kPa.
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 276 to 414 kPa. If the water
pressure to the reverse osmosis system is less
than 276 to 414 kPa:
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 241
and 827 kPa.
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 276 to 414 kPa. If the water
pressure to the reverse osmosis system is less
than 276 to 414 kPa:
Check to see whether the sediment fi lter in the
•
reverse osmosis system is blocked. Replace
the fi lter if necessary.
Allow the storage tank on the reverse osmosis
the fi lter if necessary.
Allow the storage tank on the reverse osmosis
•
system to refi ll after heavy usage.
If your refrigerator has a water fi lter, it may
If your refrigerator has a water fi lter, it may
•
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water fi lter.
in conjunction with a reverse osmosis system.
Remove the water fi lter.
If you have questions about your water pressure,
call a licensed, qualifi ed plumber.
call a licensed, qualifi ed plumber.
CONTROLLING THE TEMPERATURE
Basic temperature of Freezer and
Refrigerator Compartments
Refrigerator Compartments
The basic temperature and recommended
temperatures of the Freezer and Refrigerator
Compartments are 0 °F and 37 °F(or -18 °C
and 3 °C) respectively. If the temperature of the
Freezer and Refrigerator Compartments are too
high or low, adjust the temperature manually.
temperatures of the Freezer and Refrigerator
Compartments are 0 °F and 37 °F(or -18 °C
and 3 °C) respectively. If the temperature of the
Freezer and Refrigerator Compartments are too
high or low, adjust the temperature manually.
Controlling the Freezer
temperature
temperature
The Freezer temperature can be set between -8 °F
and 5 °F (or between -23 °C and -15 °C) to suit
your particular needs. Press the Freezer button
repeatedly until the desired temperature is shown
in the temperature display. The temperature will
change by 1 °F (or 1 °C) with each press. See
below.
Fahrenheit : 0 °F ➞ -1 °F ➞ -2 °F ➞ -3 °F ➞ -4 °F
➞ -5 °F ➞ -6 °F ➞ -7 °F ➞ -8 °F ➞ 5 °F ➞ 4 °F
➞ 3 °F ➞ 2 °F ➞ 1 °F ➞ 0 °F.
Centigrade : -18 °C ➞ -19 °C ➞ -20 °C ➞ -21 °C
➞ -22 °C ➞ -23 °C ➞ -15 °C ➞ -16 °C ➞ -17 °C
➞ -18 °C.
Keep in mind that foods like ice cream may melt
at 4 °F (or -15.5 °C). The temperature display
will move sequentially from -8 °F to 5 °F (or from
-23 °C to -15 °C).
and 5 °F (or between -23 °C and -15 °C) to suit
your particular needs. Press the Freezer button
repeatedly until the desired temperature is shown
in the temperature display. The temperature will
change by 1 °F (or 1 °C) with each press. See
below.
Fahrenheit : 0 °F ➞ -1 °F ➞ -2 °F ➞ -3 °F ➞ -4 °F
➞ -5 °F ➞ -6 °F ➞ -7 °F ➞ -8 °F ➞ 5 °F ➞ 4 °F
➞ 3 °F ➞ 2 °F ➞ 1 °F ➞ 0 °F.
Centigrade : -18 °C ➞ -19 °C ➞ -20 °C ➞ -21 °C
➞ -22 °C ➞ -23 °C ➞ -15 °C ➞ -16 °C ➞ -17 °C
➞ -18 °C.
Keep in mind that foods like ice cream may melt
at 4 °F (or -15.5 °C). The temperature display
will move sequentially from -8 °F to 5 °F (or from
-23 °C to -15 °C).
Controlling the fridge temperature
The fridge temperature can be set between 34 °F
and 44 °F (or between 7 °C and 1 °C) to suit
your particular needs. Press the Fridge button
repeatedly until the desired temperature is shown
in the temperature display. The temperature will
change by 1 °F (or 1 °C) with each press. See
below.
Fahrenheit : 37 °F ➞ 36 °F ➞ 35 °F ➞ 34 °F ➞
44 °F ➞ 43 °F ➞ 42 °F ➞ 41 °F ➞ 40 °F ➞ 39 °F
➞ 38 °F ➞ 37 °F.
Centigrade : 3 °C ➞ 2 °C ➞ 1 °C ➞ 7 °C ➞ 6 °C
➞ 5 °C ➞ 4 °C ➞ 3 °C.
The temperature control process for the Fridge
works just like the Freezer process. Press the
and 44 °F (or between 7 °C and 1 °C) to suit
your particular needs. Press the Fridge button
repeatedly until the desired temperature is shown
in the temperature display. The temperature will
change by 1 °F (or 1 °C) with each press. See
below.
Fahrenheit : 37 °F ➞ 36 °F ➞ 35 °F ➞ 34 °F ➞
44 °F ➞ 43 °F ➞ 42 °F ➞ 41 °F ➞ 40 °F ➞ 39 °F
➞ 38 °F ➞ 37 °F.
Centigrade : 3 °C ➞ 2 °C ➞ 1 °C ➞ 7 °C ➞ 6 °C
➞ 5 °C ➞ 4 °C ➞ 3 °C.
The temperature control process for the Fridge
works just like the Freezer process. Press the
Recommend Temp (Freezer) : 0 °F (or -18 °C )
Recommend Temp (Freezer) : 0 °F (or -18 °C )
DA68-02615A(0.0).indb 17
DA68-02615A(0.0).indb 17
2012.7.11 8:41:23 PM
2012.7.11 8:41:23 PM