Samsung RFG23UEBP Manuale Utente
18_
Setting up
1. Locate the height-adjuster
1
in the freezer
drawer.
Unscrew the four Phillips screws
2
slightly to
loosen the door.
2. Loosen the controller screw
3
with a Phillips
screwdriver.
3. Find the best level to align the door slope.
After adjustment, fi rst tighten screw
3
and
then screw
2
.
CHECKING THE WATER LINE
A water dispenser is one of the helpful features on
your new Samsung Refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms.
You may need to purchase a water purifying
system to do that. In order for the ice-maker to
your new Samsung Refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms.
You may need to purchase a water purifying
system to do that. In order for the ice-maker to
operate properly, a water pressure of 138~862 kPa
is required. Under normal conditions, a 170 cc
(5.75 oz.) cup can be fi lled in 10 seconds. If the
Refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure. Make
sure the water storage tank inside the Refrigerator is
properly fi lled. To do this, press the water dispenser
lever until the water runs from the water outlet.
is required. Under normal conditions, a 170 cc
(5.75 oz.) cup can be fi lled in 10 seconds. If the
Refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure. Make
sure the water storage tank inside the Refrigerator is
properly fi lled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
extra cost from your dealer.
We recommend using a water supply kit that
contains copper tubing.
contains copper tubing.
The new hose-sets supplied with the
appliance are to be used and that old
appliance are to be used and that old
hose-sets should not be reused.
Check the accessory list below.
Connecting to the water supply line
1. First, shut off the main water supply line and
turn the ice-maker off.
2. Locate the nearest cold water drinking line.
3. After connecting the water supply with water
3. After connecting the water supply with water
fi lter, turn on water supply and Flush 3L through
fi lter before use (fl ush approximately 6 minutes).
fi lter before use (fl ush approximately 6 minutes).
INSTALLING THE WATER LINE
Connecting the water line to the Refrigerator.
There are several items that you need to purchase
to complete this connection. You may fi nd these
items sold as a kit at your local hardware store.
to complete this connection. You may fi nd these
items sold as a kit at your local hardware store.
1
2
Example) The slope is about 2 mm (0.08 inch) as
shown below.
- Rotate the Height Adjuster to -2.0 to reduce the
door slope.
Slope
Reference
plane
3
1
Cold water line
2
Pipe clamp
3
Water line
installation kit
installation kit
4
Shut off valve
Water fi lter
Compression fi tting
Compression nut
DA99-03403F-11.indd 18
DA99-03403F-11.indd 18
2016. 3. 24.
10:09
2016. 3. 24.
10:09