Samsung External Dispenser Side-by-Side Manuale Utente

English - 86

4.  Insert new water filter inside 

the filter housing.

5.  When the replacement is done, press and hold 

the ‘Reset the water filter’ simultaneously for 3 
or more seconds at the center of the screen. 
(Refer to the “WATER FILTER” part on this 
manual.)

A newly installed water filter cartridge may 
cause water to briefly spurt from the water 
dispenser. 
This is due to air getting into the line. 
It should pose no problem to operation.

1.  Press the Water button, and then push the 

Dispenser Lever with a cup or glass.

2.  Flush 1 gallon of water through the filter, one 

cup or glass at a time. 
(Flush approximately 6 minutes.) 
This will clean the water supply system and 
remove air from the lines.

3.  Additional flushing may be required in some 

households.

4.  Open the refrigerator door and make sure there 

are no water leaks coming from the water filter.

IMPORTANT : The pressure of the water supply 
coming out of a reverse osmosis system going to 
the water inlet valve of the refrigerator needs to be 
between 35 and 120 psi (241 and 827 kPa). 
If a reverse osmosis water filtration system is 
connected to your cold water supply, the water 
pressure to the reverse osmosis system needs to 
be a minimum of 40 to 60 psi (276 to 414 kPa.) 
If the water pressure to the reverse osmosis 
system is less than 40 to 60 psi (276 to 414 kPa):

•  Check to see whether the sediment filter in the 

reverse osmosis system is blocked. 
Replace the filter if necessary.

•  Allow the storage tank on the reverse osmosis 

system to refill after heavy usage.

•  If your refrigerator has a water filter, it may 

further reduce the water pressure when used 
in conjunction with a reverse osmosis system. 
Remove the water filter.

If you have questions about your water pressure, 
call a licensed, qualified plumber.

To order more water filter cartridges, contact your 
authorized Samsung dealer.

DA68-02500B-13.indb   86

13. 12. 4.   �� 7:12