Samsung 2013 Smart Home Theater Manuale Utente

English  

 

|

04

Settings

Reset

Reverts all settings to their defaults 
except for the network and Smart 
Hub settings, and then starts the 
Setup function. Requires that you 
enter your security PIN. The default 
security PIN is 0000

By setting the Auto Sound Calibration (ASC) function just 
once when you relocate or install the product, you can 
have the product automatically recognize the distance 
between speakers, levels between channels, and 
frequency characteristics to create a 7.1-channel sound 
field optimized for your environment.

Auto Sound Calibration

Select whether to run and apply automatic sound 
calibration.

•  Off: The unit produces sound according to the speaker 

configuration specified in Speaker Settings.

•  On: The unit runs Auto Sound Calibration, and then 

produces sound optimized for your environment, 
according to the calibrated speaker settings.

Running Auto Sound Calibration

Before running the calibration, make sure there is no disc 
in the disc tray.

1. 

Plug the ASC microphone into the ASC IN jack.

2. 

Place the ASC microphone at the listening position.

•  Auto Sound Calibration automatically runs and 

calibrates speakers in the following sequence : 
Front L 

 Centre  Front R  Surround R  

Front Top R 

 Front Top L  Surround L  

Subwoofer

• Press the RETURN button to cancel the Auto 

Sound Calibration Setting.

When you connect this product to a network, you can 
use network based applications and functions such as 
Smart Hub and BD-LIVE, and upgrade the product's 
software through the network connection. For more 
information about accessing and using Internet services, 
see the Network Services chapter of this manual on 
pages 43~51. Instructions for configuring the network 
connection start below.

Configuring Your Network Connection

If you didn't configure your network connection during the 
initial settings procedure or you need to reset the network 
connection, follow the directions below.

Before you begin, contact your Internet Service Provider 
to find out if your IP address is static or dynamic. If it 
is dynamic, and you have a wired or wireless network, 
we recommend using the Automatic configuration 
procedures described below.

If you are connecting to a wired network, connect the 
product to your router using a LAN cable before you start 
the configuration procedure.

To begin configuring your network connection, follow 
these steps:

1. 

In the Home screen, select Settings, and then 
press the E button.

2. 

Select Network, and then press the E button.

3. 

Select Network Settings, and then press the E 
button. 

4. 

Go to the instructions for Wired networks starting 
below or the instructions for Wireless networks 
starting on page 26.

Wired Network

 

Wired – Automatic

After following Steps 1 to 3 above:

1. 

In the Network Settings screen, change Network 
type to Wired. Then, select Connect and press 
the E button. The product detects the wired 
connection, verifies the network connection and 
then connects to the network. 

2. 

When it is done, highlight OK, and then press E 
button.

 

Wired - Manual

If you have a static IP address or the automatic procedure 
does not work, you'll need to set the Network Settings 
values manually.

HT-F9730W_ZA_0604.indd   25

HT-F9730W_ZA_0604.indd   25

2013-06-04   오전 10:23:44

2013-06-04   오전 10:23:44