Samsung เครื่องซักผ้าฝาบน WT13J7EG/XST พร้อมด้วย Air Turbo, 10.5 กก. Manuale Utente
WASHING PROCEDURE
TO WASH ...................................................................................................................................
1. Before starting washing, check the following;
6. Fill water in the wash
• Connect the water supply hose and open the water tap. tub to the‘‘ L1’’lower
• Connect the power cord to the power supply outlet.
water level by carefully
• Lay the drain hose(A) down toward a sinkhole.
adjusting the tap water
and add the detergent.
7. Set the WASH TIMER 1-35 minutes.
(WITHOUT PUMP)
SOAK
• Set the WASH TIMER
to the point more
than “15” for SOAK
• Place the drain hose(A) in sink or bath
function.
about 70~80cm above the ground.
• If the WASH TIMER is
set to the point less
than “15”, it leads to
WASH only. (No SOAK)
(WITH PUMP)
• If Although the machine may stay still
maximum 5 minutes, if the WASH
TIMER is indicated over 15 minutes
position, it is just in the process
2. Set the WASH SELECTOR KNOB
of soaking and not a breakdown.
to the desired mode.
‘NORMAL or HEAVY’
8. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN’ for drain.
9. Soak-Washing
3. Set the CYCLE SELECTOR KNOB to
1) Place clothes into the WASH TUB.
‘WASH.RINSE’. (In case no drain pump.)
(‘WASH’ In case drain pump.)
2) Turn on tap or use bucket to fill the
WASH TUB with desired amount of
water.
3) Put detergent depending on the
water volume and detergent
package indications.
(Without pump) (With pump)
4) Set WASH TIMER to point between
“15” to “35” in the timer.
4. Set the WATER SELECTOR
• Soak-Washing automatically
KNOB to WASH .
starts the wash (15 min.) after the
soak (2 to 20 min.) is completed.
• The SOAK function (20 min.)
repeats the cycle that is
1.5 ~ 2.0 min. turning and
5. Put the cloths into
the next 5 min. resting 3 times.
the wash tub and
set the same water
pressure to fill the
tub so as not to
exceed ‘H3’level.
4
DC68-01942M_WT10J_VE_IB_ENG+ARAB5 5
3/29/2007 7:23:50 PM