Samsung New Boracay Split AC with Digital Inverter Technology, 1.0 TR Manuale Utente
Installing and connecting the drain hose of the indoor unit
When installing the drain hose for the indoor unit, check if condensation draining is adequate .
When passing the drain hose through the 65 mm hole drilled in the wall, check the following:
When passing the drain hose through the 65 mm hole drilled in the wall, check the following:
Wall
Indoor unit
Drain hose
The drain hose must NOT
slant upwards .
The end of the drain hose must
NOT be placed under water .
The drain hose must not
be bent .
Keep a clearance of at least 5 cm
between the end of the drain
hose and the ground .
5 cm
less
less
Do not place the end of the
drain hose in a hollow .
Ditch
Drain hose installation
1. If necessary, connect the 2 meter extension drain hose to the drain hose.
2. If you use the extension drain hose, insulate the inside of the extension drain
hose with a shield.
3. Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain hose
tightly with a clamp.
• If you do not use the other drain hose hole, block it with a rubber
stopper .
4. Pass the drain hose under the refrigerant pipe, keeping the drain hose
tight.
5. Pass the drain hose through the hole in the wall. Check if it slants
downwards as seen in the picture.
• The hose will be fixed permanently into position after finishing the installation and the gas leak test;
refer to page 48~49 for further details .
• Make sure the installed direction of the drain hose is correct .
Inadequate installation may cause condensate water leakage .
• If the drain hose is routed inside the room, insulate the hose so that dripping condensation does not damage the
furniture or floors .
• DO NOT WALL UP THE DRAIN HOSE CONNECTION !
Drain hose connection must be easy accessible and serviceable .
Drain hose hole
Shield
Drain hose
Extension drain hose
English-44
RAC BORACAY_EN_Eco-inverter IBIM_05124A-00.indd 44
2014-12-18 오후 3:06:54