Acer altos r510 mk2 Manuale Utente

 4 Configuring the system

60

Removing a Floppy Drive from the Slimline Bay 
(No Backplane Installed)

1

Observe the safety and ESD precautions at the beginning of this 
book. See 

“Safety Information.”

2

Power down the server and unplug all peripheral devices and the 
AC power cable. 

3

Remove the chassis cover. For instructions, see “Removing the 
Chassis Cover.”

4

Remove the front bezel if it is installed. For instructions, see 
“Removing and Installing the Front Bezel.” 

5

Detach the power and data cables from the rear of the floppy 
drive.

6

Detach the data cable from the server board and remove the cable 
from the chassis.

7

Push in on the blue lever at the rear of the drive carrier.

8

Slide the floppy drive carrier out through the front of the chassis.

9

Remove the screw that attaches the interposer board to the drive. 
Lift the interposer board from the drive.

10 Remove the flat flex cable from the floppy drive and from the 

interposer board.

11 Press downward on the side of the carrier to release the drive from 

the drive carrier.

12 Store the floppy drive carrier, the interposer board, the flat flex 

cable, and the floppy drive data cable for future use. 

13 Install the slimline filler panel into slimline bay if no drive is to be 

installed into the bay.

14 Install the chassis cover. For instructions, see “Installing the Chassis 

Cover.” 

15 (Optional) Install the front bezel. For instructions, see “Removing 

and Installing the Front Bezel.” 

16 Plug all peripheral devices and the AC power cable back into the 

server.