Acer altos r510 mk2 Manuale Utente

 4 Configuring the system

66

Installing or Removing a DVD/CD-RW 

or CD-ROM Drive

CAUTION: 

DVD/CD-RW and CD-ROM drives are NOT hot 

swappable. Before removing or replacing the drive, you must first 
take the server out of service, turn off all peripheral devices 
connected to the system, turn off the system by pressing the 
power button, and unplug the AC power cord from the 
system or wall outlet.

Installing a DVD/CD-RW or CD-ROM Drive into 
Slimline Bay (Backplane Installed)

NOTE: The carrier for the slimline DVD/CD-RW drive / CD-ROM 
drive was pre-installed in the slimline drive bay of your Altos R510 
Server Chassis. 

1

Observe the safety and ESD precautions at the beginning of this 
book. See 

“Safety Information.”

2

Power down the server and unplug all peripheral devices and the 
AC power cable.

3

Remove the chassis cover. For instructions, see 

“Removing the 

Chassis Cover.”

4

Remove the front bezel if it is installed. For instructions, see 

“Removing and Installing the Front Bezel.”

 

5

Push in on the blue lever at the rear of the DVD/CD-RW or CD-ROM  
drive carrier and push the carrier out through the front of the 
chassis.

6

Align the two holes at left edge of DVD/CD-RW or CD-ROM drive 
with the cutouts in drive carrier. See letter “A” in the figure 
below.

7

Lower the right side of the DVD/CD-RW or CD-ROM drive into the 
carrier until it clicks into place. See letter “B” in the figure below.