Apple EMac Manuale

Pagina di 80
    
67
Communications Regulation Information
FCC Compliance Statement
This device complies with part 15 of the FCC rules. 
Operation is subject to the following two 
conditions:  (1) This device may not cause harmful 
interference, and (2) this device must accept any 
interference received, including interference that 
may cause undesired operation. See instructions if 
interference to radio or television reception is 
suspected.
Radio and Television Interference
This computer equipment generates, uses, and can 
radiate radio-frequency energy. If it is not installed 
and used properly—that is, in strict accordance with 
Apple’s instructions—it may cause interference with 
radio and television reception. 
This equipment has been tested and found to 
comply with the limits for a Class B digital device in 
accordance with the specifications in Part 15 of FCC 
rules. These specifications are designed to provide 
reasonable protection against such interference in a 
residential installation. However, there is no 
guarantee that interference will not occur in a 
particular installation. 
You can determine whether your computer system is 
causing interference by turning it off. If the 
interference stops, it was probably caused by the 
computer or one of the peripheral devices. 
If your computer system does cause interference to 
radio or television reception, try to correct the 
interference by using one or more of the following 
measures:
• Turn the television or radio antenna until the 
interference stops. 
• Move the computer to one side or the other of the 
television or radio. 
• Move the computer farther away from the 
television or radio. 
• Plug the computer into an outlet that is on a 
different circuit from the television or radio. (That 
is, make certain the computer and the television or 
radio are on circuits controlled by different circuit 
breakers or fuses.) 
If necessary, consult an Apple-authorized service 
provider or Apple. See the service and support 
information that came with your Apple product. Or, 
consult an experienced radio/television technician 
for additional suggestions. 
Changes or modifications to this product not 
authorized by Apple Computer, Inc., could void the 
EMC compliance and negate your authority to 
operate the product.
This product was tested for EMC compliance under 
conditions that included the use of Apple peripheral 
devices and Apple shielded cables and connectors 
between system components. It is important that 
you use Apple peripheral devices and shielded 
cables and connectors between system components 
to reduce the possibility of causing interference to 
radios, television sets, and other electronic devices. 
You can obtain Apple peripheral devices and the 
proper shielded cables and connectors through an 
Apple-authorized dealer. For non-Apple peripheral 
devices, contact the manufacturer or dealer for 
assistance. 
Responsible party (contact for FCC matters 
only):
  Apple Computer, Inc. Product Compliance, 1 
Infinite Loop M/S 26-A, Cupertino, CA 95014-2084, 
408-974-2000.
Industry Canada Statement
Complies with the Canadian ICES-003 Class B 
specifications. Cet appareil numérique de la classe B 
est conforme à la norme NMB-003 du Canada. Cet 
appareil numérique de la classe B est conforme à la 
norme NMB-003 du Canada.
VCCI Class B Statement
European Community
Complies with European Directives 72/23/EEC and 
89/336/EEC.
Laser Information
Making adjustments or performing procedures other 
than those specified in your equipment’s manual 
may result in hazardous radiation exposure.
Do not attempt to disassemble the cabinet 
containing the laser. The laser beam used in this 
product is harmful to the eyes. The use of optical 
instruments, such as magnifying lenses, with this 
product increases the potential hazard to your eyes. 
For your safety, have this equipment serviced only 
by an Apple-authorized service provider. 
If you have an internal Apple CD-ROM, DVD-ROM, or 
DVD-RAM drive in your computer, your computer is 
a Class 1 laser product. The Class 1 label, located in a 
LL2385.book  Page 67  Thursday, September 4, 2003  5:20 PM