abit va-10 Manuale Utente
2-4 Chapter
2
1. Locate the Socket 462 on this motherboard. Pull the CPU release lever sideways
to unlatch and then raise it all the way up.
2. Align the CPU notch to the socket notch for CPU. Drop the processor with its pin
side down into the CPU socket. Do not use extra force to insert CPU; it only fit in
one direction. Close the CPU release lever.
one direction. Close the CPU release lever.
3. Remove the plastic film adhesive on the heatsink. Make sure the stepped portion
of the heatsink is facing toward the end of the socket that reads “Socket 462”. Put
the heatsink faces down onto the processor until it covers the processor
completely.
the heatsink faces down onto the processor until it covers the processor
completely.
4. Push down the short end of the retaining clip first to lock up with the center lug at
the bottom of the socket.
5. Use a screwdriver to insert into the slot at the long end of the retaining clip. Push
the clip downward to lock up with the center lug at the top of the socket. The
heatsink & fan assembly is now firmly attached on the CPU socket.
heatsink & fan assembly is now firmly attached on the CPU socket.
6. Attach the fan connector of Heatsink & Fan Assembly with the fan connector on
the motherboard.
ATTENTION: Do not forget to set the correct bus frequency and multiple for your
processor.
processor.
VA-10/VA-11