Acronis backup recovery 10 workstation Manuale Utente

To specify pre/post data capture commands

1. Enable pre/post data capture commands execution by checking the following options:

Execute before the data capture

Execute after the data capture

2. Do any of the following:

Click Edit to specify a new command or a batch file

Select the existing command or the batch file from the drop-down list

3. Click OK.

Pre-data capture command

To specify a command/batch file to be executed before data capture

1. In the Command field, type a command or browse to a batch file. The program does not support

interactive commands, i.e. commands that require user input (for example, "pause".)

2. In the Working directory field, specify a path to a directory where the command/batch file will be

executed.

3. In the Arguments field specify the command’s execution arguments, if required.

4. Depending on the result you want to obtain, select the appropriate options as described in the

table below.

5. Click Test command to check if the command is correct.

Check box

Selection

Fail the backup task if the
command execution fails

Selected

Cleared

Selected

Cleared

Do not perform the data
capture until the command
execution is complete

Selected

Cleared

Result

Preset

Perform the data
capture only after
the command is
successfully
executed. Fail the
task if the command
execution fails.

Perform the data
capture after the
command is
executed despite
execution failure
or success.

N/A

Perform the data
capture
concurrently with
the command and
irrespective of the
command execution
result.

Post-data capture command

To specify a command/batch file to be executed after data capture

1. In the Command field, type a command or browse to a batch file. The program does not support

interactive commands, i.e. commands that require user input (for example, "pause".)

2. In the Working directory field, specify a path to a directory where the command/batch file will be

executed.