ademco vista-100 Manuale Utente

Your fire alarm system (if installed) is on 24 hours a day,
providing continuous protection. In the event of an emergency,
the installed smoke and heat detectors will automatically send
signals to your Control/Communicator, triggering a loud,
interrupted sound from the Keypad.  An interrupted sound will
also be produced by optional exterior sounders. A FIRE message
will appear at your Keypad and remain on until you silence the
alarm.

1. Should you become aware of a fire emergency before your

detectors sense the problem, go to your nearest Keypad and
manually initiate an alarm by pressing the panic key pair
assigned as FIRE emergency (if programmed by the installer)
and hold down for at least 2 seconds.

2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and

notify your local Fire Department immediately.

4. If no flames or smoke are apparent, investigate the cause of

the alarm. The zone descriptor of the zone(s) in an alarm
condition will appear at the Keypad.

1. Silence the alarm by entering your code and pressing the

OFF key. To clear the display, enter your code and press the
OFF key again.

2. If the Keypad does not indicate a READY condition after the

second OFF sequence, press the READY key to display
the zone(s) that are faulted.  Be sure to check that smoke
detectors are not responding to smoke or heat producing
objects in their vicinity.  Should this be the case, eliminate the
source of heat or smoke.

3. If this does not remedy the problem, there may still be smoke

in the detector.  Clear it by fanning the detector for about 30
seconds.

4. When the problem has been corrected, clear the display by

entering your code and pressing the OFF key.