Alcatel-Lucent speedtouch 536 Manuale Utente
Chapter 2
Basic Installation
E-DOC-CTC-20050429-0034 v1.0
7
2.2 Connecting the Hardware
Wiring
The figure below shows all possible types of connection to the SpeedTouch™.
Proceed as follows:
1
Use the grey DSL cable to wire the SpeedTouch™ DSL port to your telephone
wall outlet or distributed filter.
wall outlet or distributed filter.
2
Plug in the coaxial jack from the electric power supply adapter into the
SpeedTouch™’15VAC’ port and the other end to the wall outlet.
SpeedTouch™’15VAC’ port and the other end to the wall outlet.
3
During the SpeedTouch™ Home Install Wizard, you will be asked to make one of
following connections:
following connections:
Connect the yellow RJ-45 Ethernet cable to the yellow Ethernet port on
your SpeedTouch™ and the other end to the computer’s Ethernet port.
your SpeedTouch™ and the other end to the computer’s Ethernet port.
Connect the blue USB cable to the blue USB port on your SpeedTouch™
and the other end to the computer’s USB port.
and the other end to the computer’s USB port.
Powering the
SpeedTouch™
To power on the SpeedTouch™, press the power button on the SpeedTouch™ rear
panel.
During the start-up procedure, the power LED on the front panel is lit red for some
seconds. As soon as the power LED is solidly lit green, your SpeedTouch™ is ready
for service. After another couple of seconds, also the DSL LED will light green.
If these LEDs do not light, please refer to
panel.
During the start-up procedure, the power LED on the front panel is lit red for some
seconds. As soon as the power LED is solidly lit green, your SpeedTouch™ is ready
for service. After another couple of seconds, also the DSL LED will light green.
If these LEDs do not light, please refer to
. A
comprehensive LED overview can be found in the SpeedTouch™ User’s Guide.
To power off your SpeedTouch™, press the same button.
To power off your SpeedTouch™, press the same button.
The colour coded printing on the backpanel of your SpeedTouch™ will
facilitate matching the colour coded cables.
facilitate matching the colour coded cables.
If you are not using the USB connection on the SpeedTouch™536,
make sure to place the provided protective cap on the blue USB
port of the SpeedTouch™536.
make sure to place the provided protective cap on the blue USB
port of the SpeedTouch™536.
DSL
RESET
ON/OFF
ETHERNET
15VAC
USB