Alcatel-Lucent OmniAccess 3500 Guida Utente
A AC power connector
F USB 2.0 ports 0 and 1 (not used)
B PS 2 Mouse port (not used)
G Private Network Interface (LAN)
C Serial Port (DB9) (not used)
H Video connector (not used)
D Public Network Interface (WAN)
I PS2 Keyboard port (not used)
E PCI-E/X Add-in Card Slot (not used)
Table 1 – Back panel connectors and data ports
Gateway Setup Instructions
The following procedures explain how to install and start up your gateway. For more
detailed instructions, see the Gateway Installation Guide.
detailed instructions, see the Gateway Installation Guide.
Physical Installation
1. Attach the gateway to an appropriate rack using the supplied rack mount
hardware (optional).
2. Take the power cord that comes with the unit and connect it to the power supply
on the back of the gateway. The gateway automatically powers up after the
power source is connected. If the power does not come up, use the supplied key
to remove the bezel. If no lights are displayed, push the power-on button and
reset the bezel.
to remove the bezel. If no lights are displayed, push the power-on button and
reset the bezel.
Configuration
After physical installation of the gateway as described in the previous section, you
must configure the network and other basic parameters using the pre-configured IP
address of the private network interface (LAN) of the gateway (192.168.1.1).
1. Connect a computer to the LAN (private) port of the gateway using an Ethernet
must configure the network and other basic parameters using the pre-configured IP
address of the private network interface (LAN) of the gateway (192.168.1.1).
1. Connect a computer to the LAN (private) port of the gateway using an Ethernet
cable. Ensure that the LED on the Ethernet interface is lit.
2. Open a web browser on the computer.
3. Type the following HTTPS address in the address bar: https://192.168.1.1 (make
3. Type the following HTTPS address in the address bar: https://192.168.1.1 (make
sure that no proxy server is configured on your web browser).
4. You will be asked to enter the login ID and password for the super administrator
(the default userid is “admin” and the password is “evros”).
5. After configuring the login ID and password, the management system basic
configuration GUI appears. Click New.
6. The Gateway Configuration (Add) window appears.
7. Type the appropriate information into the fields that do not contain default
7. Type the appropriate information into the fields that do not contain default
values (see the Gateway Installation Guide for detailed field descriptions).
8. Click Save when you are finished entering information.
9. A window appears stating that the operation has been successful.
9. A window appears stating that the operation has been successful.