Aopen aoi-702u Manuale Utente
AOpen Wireless PC Adapter
Figure 2 Wireless Configuration Utility program
The utility is divided into five tabs: STATUS, STATISTICS,
SITE SURVEY, ENCRYPTION, ADVANCED, AND
VERSION.
STATUS (see figure 2)
It shows the information of the linkage between this
wireless pc adapter and the wireless access point.
Click the CHANGE button to change the set ups, and click the
SUMIT button after the configuration has been changed.
wireless pc adapter and the wireless access point.
Click the CHANGE button to change the set ups, and click the
SUMIT button after the configuration has been changed.
Operation Mode
The Operation Mode setting determines the structure of your
wireless network. The default is Infrastructure mode.
The Operation Mode setting determines the structure of your
wireless network. The default is Infrastructure mode.
AOpen Wireless PC Adapter
Ad Hoc: The Ad-Hoc mode is for a simple peer-to peer
network. ( with no Access Point needed)
Infrastructure: The infrastructure mode allows wireless
users to be able to access to the wired (existed) network by
using an Access Point. With Multiple access points, they
provide roaming, which extend the coverage of the wireless
network.
using an Access Point. With Multiple access points, they
provide roaming, which extend the coverage of the wireless
network.
Channel
It specifies the channel used in wireless communication and should
be set to the same channel with other wireless nodes in the same
wireless network. The default channel is channel 6.
SSID (Service Set Identifier)
SSID is the unique name shared among all nodes in a wireless
network. The SSID must be the same for all the nodes on the
network, and is case sensitive. The default SSID is aopen.
TX Rate: This is the current transfer rate for the network card. It
should set to Fully Automatic to get the optimal performance
State
State is to display the current state of the linkage.
It shows the BSS ID of the associated Access Point which wireless
connects to the adapter. The state is showing “Scanning” when the
adapter is searching for an available access point. Sometimes it is
because the adapter can not detect the SSID for an access point
within the range. An error message may be displayed when the
driver failed to initialize.
Signal Strength
It is active only when the node is in Infrastructure Mode. Here
displays the signal strength of the connection.
It specifies the channel used in wireless communication and should
be set to the same channel with other wireless nodes in the same
wireless network. The default channel is channel 6.
SSID (Service Set Identifier)
SSID is the unique name shared among all nodes in a wireless
network. The SSID must be the same for all the nodes on the
network, and is case sensitive. The default SSID is aopen.
TX Rate: This is the current transfer rate for the network card. It
should set to Fully Automatic to get the optimal performance
State
State is to display the current state of the linkage.
It shows the BSS ID of the associated Access Point which wireless
connects to the adapter. The state is showing “Scanning” when the
adapter is searching for an available access point. Sometimes it is
because the adapter can not detect the SSID for an access point
within the range. An error message may be displayed when the
driver failed to initialize.
Signal Strength
It is active only when the node is in Infrastructure Mode. Here
displays the signal strength of the connection.