att 1485 Manuale Utente

¥

NOTE: Install this telephone away from electronic
equipment, such as personal computers,television 
sets or microwave ovens. Avoid excessive heat,cold,
dust or moisture.

1

Connect the corded handset to the base.

2

Connect the telephone line cord. (figure a)

3

Connect the power cord to the base and 
an electrical outlet not controlled by a wall 
switch. (figure a)  The answer ON/OFF light 
goes on, and CL flashes in the message window.

Use only the power cord supplied with this
p ro d u c t . If you need a re p l a c e m e n t , call 1-800-
2 2 2 – 3 1 1 1 .

4

Check for dial tone .

• Lift the handset, you should hear a dial tone.

¥

NOTE: For Wall Mount Installation see page 5 in the
User Manual.

1

Connect the power cord. Be sure to plug the cord

into an electrical outlet not controlled by a wall 
switch.
2

Install the handset batter y. Use NiCd Replacement 
Battery 3301,SKU# 91076. (figure b)

3

Charge the handset batter y.

• Place the handset in the remote charging 

stand.The CHARGING light goes on.

• Charge the battery at least 12 hours.

4

Check for dial tone.

• After the batteries are charged,lift the handset 
and press 

; you should hear a dial tone.

Standard

electrical

outlet

Power Cord

Line Cord

figure b

figure a

Modular

telephone

jack

a) Remove battery

compartment 
cover by
pressing on the 
indentation and 
sliding 
downward.

c) Place battery pack in

compartment with
the wires in the
lower left corner,
along the bottom of
the battery pack.

b) Align two holes

in plug with
socket pins,
and snap the
plug into place.

d) Replace cover

by sliding it up
into place.