att 5630 Manuale Utente

14.  Charge the handset batteries for 10 hours.  Place the handset in the base and let the batteries charge

for 10 hours.  You can use your phone before the 10 hours are up, but be sure to return the handset to
the base so it can charge fully.  The CHARGING Light on the base unit will light to show the batteries
are charging.

15.  Check for dial tone.  After the batteries are charged, pick up the handset and extend the handset and

base antennas.  Now press PHONE on the handset.  The PHONE Light should light, and you should
hear a dial tone.

16.  Set Answering System Features.  To fully utilize this system, you need to:

a)  Set the clock
b)  Record an announcement
c)  Set system to answer calls
d)  Set RING SELECT switch

Telephone Operation

You can make calls from the handset anywhere within range of the base.  Usually when you use the handset
close to the base, you won’t have to extend the handset antenna.  However, your phone will work best if you
always keep both antennas fully extended.

Pick up the handset and press PHONE.  The PHONE Lights on the handset and base will both light.  When
you hear a dial tone, dial the number.

If you make a mistake when dialing, press OFF to hang up, then press PHONE to get dial tone again.

You must always press PHONE before you can dial a call on the handset.

You can adjust the handset volume using the switch on the side of the handset.

If you are near the base, you can place the handset back in the base to end the call.  If you are using the
handset away from the base, you must press OFF to end the call – otherwise your phone will be “off the
hook” and callers will get a busy signal.

When you receive a call, the handset will ring if the RINGER switch is set to ON.  If your phone rings when
the handset is in the base, just pick up the handset and answer the call as you would on any other phone.
Occasionally, especially when you pick up the handset between rings, you may not be connected.  If this
happens, press PHONE on the handset to connect the call.

If the handset rings when it’s out of the base, pick up the handset, extend the antenna and press PHONE to
answer the call.

Hanging Up:  To end a call, either place the handset back on the base, or press OFF on the handset.

Slide the handset VOLUME Control toward the top of the handset to increase, or toward the bottom of the
handset to decrease, the sound level in the handset.  This will not affect what the other party is hearing.

Your telephone can redial the last number dialed.  Press PHONE for the dial tone, then press REDIAL.  The
phone number will remain in the redial memory until you dial another number.