Axis 20443r2 Manuale Utente
AXIS 230
Unit Connections
49
Appendix D - Unit Connections
The D-Sub Connector
The AXIS 230 provides one 9-pin D-sub connector, providing the physical interface for an
RS-232 port, used for connecting accessory equipment; such as stand-alone Pan/Tilt
devices for the remote positioning of connected video cameras.
A diagram of the RS-232 connector, complete with pin assignment table, is shown below.
The Terminal Block
The terminal block is located on the rear panel and provides the interface to a single
transistor output, two digital inputs, an RS-485 interface and GND.
This section describes the pinout, interface support and the control and monitoring
This section describes the pinout, interface support and the control and monitoring
functions provided by the terminal block.
Terminal Block Pinout
Pin
Function
1
CD
2
- RXD
3
- TXD
4
DTR
5
GND
6
DSR
7
RTS
8
CTS
9
RI
Pin
Function Description
1
GND
2
Digital Input 1
1k internal pull-up. Connect to GND to activate.
3
Digital Input 2
1k internal pull-up. Connect to GND to activate.
4
Digital output
Maximum current sink of 100mA (via logical 0 output.) Handles a maximum voltage of
24V DC, which is grounded at a maximum of 100mA. This output has an open-collec-
tor NPN transistor with the emitter connected to pin 1. If used with an external relay,
a diode must be connected in parallel with the load, for protection against voltage
transients.
24V DC, which is grounded at a maximum of 100mA. This output has an open-collec-
tor NPN transistor with the emitter connected to pin 1. If used with an external relay,
a diode must be connected in parallel with the load, for protection against voltage
transients.
5
RS-485-A (non-inverting)
A half-duplex RS-485/422 interface for controlling auxiliary equipment.
6
RS-485-A (inverting)
5
4
3
2
1
6
7
8
9