applied-energy britex Istruzione Sull'Installazione
INSTALLATION INSTRUCTIONS
FOR COMPLETE FAN LIGHT KIT
BriteX LoVolt & BriteX Turbo
GENERAL MOUNTING AND SAFETY NOTES
1. WHEN INSTALLING FANS SWITCH OFF MAINS SUPPLY BEFORE MAKING ELECTRICAL
CONNECTIONS. All wiring must comply with current IEE regulations. If in doubt, consult a qualified electrician.
2. Extraction fans should not be located in rooms containing open flued appliances.
3. Do not install 240V fans in a shower or bathroom application where the fan may be within reach of someone using a
3. Do not install 240V fans in a shower or bathroom application where the fan may be within reach of someone using a
bath or shower, or subjected to water spray (zones 0, 1 and 2). The 12V VentLight is suitable for use in shower
cubicles.
cubicles.
4. Do not install fan directly behind shutter grille.
5. These fans are double insulated and do not require an earth connection.
6. For systems incorporating back draught shutters ensure that the shutter grille is mounted on a vertical wall with the
5. These fans are double insulated and do not require an earth connection.
6. For systems incorporating back draught shutters ensure that the shutter grille is mounted on a vertical wall with the
shutters orientated correctly. Take care to ensure that shutter movement is not restricted.
7. Maximum fan operating temperature 40°C.
8. Xpelair guarantees for 3 years against defects in the materials or manufacture of the Xpelair fan range from the date of
8. Xpelair guarantees for 3 years against defects in the materials or manufacture of the Xpelair fan range from the date of
purchase (when installed to manufacturers requirements and used in a normal domestic operation) (2 years for the
BriteX Turbo).
BriteX Turbo).
Timer versions
Timer is adjustable between 2 to 20 minutes run time. Fans have been factory set at minimum. Using a small flat bladed
screwdriver adjust dial on circuit board by turning clockwise to reduce run time and anticlockwise to extend run time
(BX100WT and BX100CT models only).
screwdriver adjust dial on circuit board by turning clockwise to reduce run time and anticlockwise to extend run time
(BX100WT and BX100CT models only).
To suit Timer Models: BX100WT, BX100CT, BX100+WT, BX100+CT
To suit Standard Models: BX100W, BX100C, BX100+W, BX100+C
Note: a means for
disconnection in all poles
must be incorporated in the
fixed wiring in accordance
with the wiring rules. We
recommend a ceiling
switch mounted in a
suitable position.
SL = Switched Live.
disconnection in all poles
must be incorporated in the
fixed wiring in accordance
with the wiring rules. We
recommend a ceiling
switch mounted in a
suitable position.
SL = Switched Live.
Note: a means for
disconnection in all poles
must be incorporated in
the fixed wiring in
accordance with the
wiring rules. We
recommend a ceiling
switch mounted in a
suitable position.
disconnection in all poles
must be incorporated in
the fixed wiring in
accordance with the
wiring rules. We
recommend a ceiling
switch mounted in a
suitable position.