Juniper CBL-PWR-10AC-STR-CH Manuale Utente
NOTE:
After powering off a power supply, wait at least 60 seconds before
turning it back on. After powering on a power supply, wait at least 60
seconds before turning it off.
seconds before turning it off.
If the router is completely powered off when you power on the power
supply, the Routing Engine boots as the power supply completes its startup
sequence. If the Routing Engine finishes booting and you need to power
off the router again, see
supply, the Routing Engine boots as the power supply completes its startup
sequence. If the Routing Engine finishes booting and you need to power
off the router again, see
.
After a power supply is powered on, it can take up to 60 seconds for status
indicators—such as the output status LED on the power supply, the
command display output, and messages on the LED display on the craft
interface—to indicate that the power supply is functioning normally. Ignore
error indicators that appear during the first 60 seconds.
indicators—such as the output status LED on the power supply, the
command display output, and messages on the LED display on the craft
interface—to indicate that the power supply is functioning normally. Ignore
error indicators that appear during the first 60 seconds.
Figure 53: Installing an AC Power Supply
Related
Documentation
•
•
•
•
•
Replacing an M7i AC Power Cord
The AC power cord that plugs into the appliance inlet on the faceplate of each AC power
supply provides direct connection to the external power source.
supply provides direct connection to the external power source.
1.
2.
3.
Copyright © 2012, Juniper Networks, Inc.
114
M7i Multiservice Edge Router Hardware Guide