Arcam dv89 Manuale Utente

DV89

DV89

Using the remote control

OK

ANGLE

CD

DVD

SETUP

STATUS

SRCH

ZOOM

AUDIO

MEM

RTN

P

MODE

SUBT

TITLE

MENU

RPT

CLEAR

0

PROG

A-B

7

8

9

DISP

4

5

6

CD

DVD

1

2

3

MUTE

OPEN

CD/DVD  REMOTE

CR-314

Ensure that DVD mode is selected using the 

 

toggle button. The ‘DVD’ LED above the 

 button 

is lit briefly when DVD mode is selected.

Dims or turns the DV89’s display on or off. Turning the display off 

generally gives a slight improvement in sound quality.

Pressing 

 once turns the display off; twice dims the display. 

To restore the display to full brightness, press 

 a third time.

This button enables you to repeat a selected 

section from the disc (see page 14).

Press 

 to cycle through the repeat play options.

Use 

 within the ‘Program’ and ‘Bookmark’ menus to clear 

a numeric field (see pages 14–15).

This allows direct access to individual tracks on audio CDs. To 
select a track, press the corresponding keypad button followed 
by 

. For tracks greater than 9, enter the digits in sequence. 

For example, to play track 15, press 

, then 

, then 

.

You can program a selection of up to 20 chapters/tracks 
from a disc to play in any order. Press 

 to access the 

’Programme’ menu (see pages 15 and 17).

Stops sound to the speaker outputs of certain Arcam amplifiers.

Volume +/– 
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume (

+/–) controls and 

 button have 

no effect on the audio output level of the DVD players.

NOTE: Remember to install the two AAA batteries 
supplied before trying to use your remote control.
Do not place anything in front of the display area on the 
DVD player (where the IR receiver is located), or the 
remote control may not work.

Opens and closes the disc tray.

DVD-audio: Some DVD-audio discs allow the user to 
browse through images (photographs of the artist, lyrics, 
etc.) while music is being played. Use the   or   buttons 
to change to the previous/next page. Note that this is not 
availble on all DVD-audio discs.
Other discs: Press   or   on the remote control to play 
slow forward or backwards. There are four speeds of 
slow playback: 1/5, 1/4, 1/3 and 1/2. Press the button 
repeatedly to cycle through the different speeds. To resume 
normal playback speed, press 

.

NOTE: Slow play does not apply to audio CDs or DVD-audio 
discs.

Use the cursor pad to navigate the On Screen Display (OSD) and 

menu pages. Confirm your selection with the 

 button.

Pause ( ), Play ( ) and Stop ( ) (see page 11).

Play fast (

 

) and Skip (    ) chapters/tracks in both 

directions (see page 11).

These buttons are described on the facing page.

Press 

 to toggle the standby state of the DVD player. 

Note that Arcam CD players are not controlled by this button.